No.29 Does Not Upshift In M Position: Notes
WARNING: This page is about a different variant/trim than selected.
| 29 |
Does not upshift in M position |
| DESCRIPTION |
- Gear position indicator light in instrument cluster illuminates, but the vehicle does not upshift when the selector lever is pushed to "+" side.
|
| POSSIBLE CAUSE |
- Up switch, M position switch (built-in selector lever component) or related wiring harness malfunction
- Multiplex communication system malfunction (Shift position signal is incorrect.)
- Between TCM and instrument cluster
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)
|