No.27 Gear Position Indicator Light Does Not Illuminate In D Or M Position: Notes
WARNING: This page is about a different variant/trim than selected.
| 27 |
Gear position indicator light does not illuminate in D or M position |
| DESCRIPTION |
- Gear position indicator light in instrument cluster does not illuminate in D or M position and ignition switch at ON.
|
| POSSIBLE CAUSE |
- M position switch (built-in selector lever component), instrument cluster, or related wiring harness malfunction
- Multiplex communication system malfunction (Shift position signal is incorrect.)
- Between TCM and instrument cluster
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)
|