No.24 Engine Stalls When Shifted To D Or In R Position: Notes
WARNING: This page is about a different variant/trim than selected.
| 24 |
Engine stalls when shifted to D or in R position |
| DESCRIPTION |
- Engine stalls when shifting from N or P position to D or R position at idle.
|
| POSSIBLE CAUSE |
- The malfunction is on the engine control side (e.g. electronic controlled throttle system). Otherwise, the malfunction is in the input/turbine speed sensor (engine sometimes starts) or the TCC circuit (engine always stalls).
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)
|