No.23 Transaxle Overheats: Notes
WARNING: This page is about a different variant/trim than selected.
| 23 |
Transaxle overheats |
| DESCRIPTION |
- Burnt smell emitted from transaxle.
- Smoke emitted from transaxle.
|
| POSSIBLE CAUSE |
- The malfunction is restricted to the hindrance of coolant at the oil cooler. In addition, overheating of the transaxle may be caused by a malfunction of the TFT sensor.
- Line pressure low
- ATF level low
- Incorrect accelerator opening signal
- Line pressure control solenoid malfunction
- Oil cooler malfunction (Foreign material mixed in with ATF)
- TFT sensor malfunction
- Excessive amount of ATF
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)
|