Initial Learning
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing initial learning, be aware of other vehicles, people, and other impediments in order to avoid an accident.
NOTE:
- While self-learning control gradually reduces shock during normal driving, initial learning is performed to initially learn a certain amount of driving conditions.
- Warm-up
- Increase the ATF temperature by leaving the vehicle idling or performing city driving. Verify that the ATF temperature is between 66-110 °C {151-230 °F} . If the ATF temperature is outside this range, work to bring it inside the range.
CAUTION:- Do not raise the ATF temperature by stalling the engine.
NOTE:- If the ATF temperature is not between 66-110 °C {151-230 °F}
, initial learning cannot be performed.
Before learning, inspect for variable shift shock.
- Garage shift learning
- With the vehicle standing still, depress the brake pedal and keep the selector lever in N position for 3 s . Then, shift the selector lever from the N position into D position, and maintain in this condition for 3 s . Repeat this procedure 5 times . Then repeat it 5 times in the same way for R position.
- Gear shift control learning
- In D position, with the accelerator opening between 25-30% , drive until you reach 6th gear and a vehicle speed of 80 km/h {50 mph} or higher. Then, release the accelerator pedal and coast, and bring the vehicle to a stop in at least 60 s . Repeat this procedure 10 times .
- Inspect learning results
- Verify that variable speed shock and shift shock have decreased compared to the conditions before learning.