No.1 Vehicle Does Not Move In D Or In R Position: Notes
WARNING: This page is about a different variant/trim than selected.
| 1 |
Vehicle does not move in D or in R position |
| DESCRIPTION |
- Vehicle does not move when accelerator pedal is depressed.
|
| POSSIBLE CAUSE |
- If the vehicle does not move in D or R position, basically, the malfunction is in the ATX. (Vehicle will move even with a malfunction in the TCM.) Since a malfunction is in the sensor circuit or output circuit is the cause of the malfunction in the ATX, inspect the sensors, output circuit, and the related wiring harnesses.
- Clutch slippage, worn (D position-C1 clutch, One-way clutch, R position-C3 clutch, B2 brake)
- Line pressure low
- Shift solenoid A malfunction
- Shift solenoid B malfunction
- Shift solenoid C malfunction
- Shift solenoid E malfunction
- Line pressure control solenoid malfunction
- Shift solenoid F malfunction
- Sensor ground malfunction
- Body ground malfunction
- Control valve body malfunction
- Selector lever malfunction
- Parking mechanism not operating properly
- Torque converter malfunction
- Coupler component malfunction
- N position learning is not performed
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)
|