DTC P2806:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P2806:00 |
Neutral position learning (Not performed yet) |
| DETECTION CONDITION |
- Conditions: Diagnosis tester request "N position adaptation"
- Circumstances: "N position adaptation" not performed
- Time period: Determined after 1 time
Diagnostic support note:
- The MIL does not illuminate.
- The AT warning light illuminates.
- PENDING CODE is not available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- Not set "N" position when writing condition
- Selector cable mis-adjustment
|
| SYSTEM WIRING DIAGRAM |
- |