DTC P1783:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P1783:00 |
ATF high oil temperature malfunction |
| DETECTION CONDITION |
- Conditions: Engine speed < 800 rpm and TCM communication normal
- Circumstances: ATF temperature of 150 °C {302 °F} or above detected
- Time period: Determined after 1 time lasting 12 seconds
Diagnostic support note:
- The MIL does not illuminate.
- The AT warning light does not illuminate.
- PENDING CODE is not available.
- FREEZE FRAME DATA is not available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Request torque limitation
|
| POSSIBLE CAUSE |
- High engine load drive (Driving a steep gradient at a low speed)
- Insufficient or excess level of ATF
- Deteriorated ATF
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |