DTC P1700:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P1700:00 |
Hydraulic pressure unit (at R position) |
| DETECTION CONDITION |
- Conditions: In R position, VSS rotation 500rpm or below
- Circumstances: Difference between engine and Input/turbine speed sensor rotations below 150rpm, not in reverse gear detected
- Time period: Determined after 1 times lasting 0.8 or more seconds
Diagnostic support note:
- The MIL does not illuminate.
- The AT warning light illuminates.
- PENDING CODE is not available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Inhibits learning control
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Line pressure malfunction
- Stall speed malfunction
- Solenoid valve malfunction
- Shift solenoid A
- Shift solenoid B
- Shift solenoid E
- Clutch/brake malfunction
- ATX malfunction
- Control valve body malfunction
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |