DTC P0942:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P0942:00 |
Hydraulic pressure unit (at D position) |
| DETECTION CONDITION |
- Conditions: In D position, VSS rotation 500rpm or below
- Circumstances: Difference between engine rotation and Input/turbine speed sensor rotation below 150rpm, not in 1GR detected
- Time period: Determined after 1 times lasting 0.8 or more seconds
Diagnostic support note:
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Line pressure malfunction
- Stall speed malfunction
- Solenoid valve malfunction
- Shift solenoid A
- Shift solenoid B
- Shift solenoid C
- Clutch/brake malfunction
- ATX malfunction
- Control valve body malfunction
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |