DTC P0867:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P0867:00 |
ATF pressure |
| DETECTION CONDITION |
- Conditions: In D position, VSS rotation 500rpm or below, ATF temperature 0 °C or more, Not shifting, 1GR, 2GR, 3GR or 4GR
- Circumstances: Difference between engine speed and Input/turbine speed sensor rotation below 150rpm, not in 1GR detected, input revolution > output revolution x 1GR ratio + 400rpm
- Time period: Determined C1 and C2 clutch not engaged after 1 times lasting 0.1 or more continuous
Diagnostic support note:
- The MIL does not illuminate.
- The AT warning light illuminates.
- PENDING CODE is not available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- |
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Line pressure malfunction
- Stall speed malfunction
- Solenoid valve malfunction
- Shift solenoid A
- Shift solenoid B
- Shift solenoid C
- Clutch/brake malfunction
- ATX malfunction
- Control valve body malfunction
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |