DTC P0762:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P0762:00 |
Shift solenoid C stuck on |
| DETECTION CONDITION |
- Conditions: ATF temperature -20 °C {68 °F} or more, TCM communication normal, driving in D position, output VSS rotation 300 rpm or more (wheel not spinning)
- Circumstances: Abnormal shifting detected
- Time period: Determined after 5 times
Diagnostic support note:
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Line pressure malfunction
- Solenoid valve malfunction
- Line pressure control solenoid
- Shift solenoid A
- Shift solenoid B
- Shift solenoid C
- ATX malfunction
- Control valve body malfunction
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |