Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has the FREEZE FRAME DATA been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT COUPLER COMPONENT CONNECTOR FOR POOR CONNECTION Switch the ignition OFF (LOCK). Remove the TCM. (See TCM REMOVAL/INSTALLATION .) Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 8.
3		No	Go to the next step.
4	INSPECT INPUT/TURBINE SPEED SENSOR CIRCUIT FOR SHORT TO GND Switch the ignition OFF (LOCK). Inspect for continuity between the following circuits: Coupler component terminal B12 (wiring harness-side) and body GND Coupler component terminal B13 (wiring harness-side) and body GND Is there continuity?	Yes	Repair or replace the wiring harness for a possible short to GND, then go to Step 8.
4		No	Go to the next step.
5	INSPECT INPUT/TURBINE SPEED SENSOR CONNECTOR FOR POOR CONNECTION Switch the ignition OFF (LOCK). Disconnect the input/turbine speed sensor connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 8.
5		No	Go to the next step.
6	INSPECT INPUT/TURBINE SPEED SENSOR Inspect the input/turbine speed sensor. (See INPUT/TURBINE SPEED SENSOR INSPECTION .) Is there any malfunction?	Yes	Replace the input/turbine speed sensor, then go to Step 8. (See INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION .)
6		No	Go to the next step.
7	INSPECT INPUT/TURBINE SPEED SENSOR CIRCUIT FOR OPEN CIRCUIT Switch the ignition OFF (LOCK). Inspect for continuity between the following circuits: Input/turbine speed sensor terminal A (wiring harness-side) and coupler component terminal B12 (wiring harness-side) Input/turbine speed sensor terminal B (wiring harness-side) and coupler component terminal B13 (wiring harness-side) Is there continuity?	Yes	Go to the next step.
7		No	Repair or replace the wiring harness for a possible open circuit, then go to the next step.
8	VERIFY DTC TROUBLESHOOTING COMPLETED Make sure to reconnect all the disconnected connectors. Clear the DTC using the M-MDS. Perform the following procedure to ensure that the DTC has been resolved: Start the engine. Warm up the engine to normal operating temperature. Drive the vehicle, two separate times, in D position at 20 km/h {12 mph} or more for 150 s or more. Is the same DTC present?	Yes	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION .)
8		No	Go to the next step.
9	VERIFY NO DTCs ARE PRESENT Perform the "Reading DTCs Procedure". (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
9		No	DTC troubleshooting completed.