DTC P0603:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P0603:00 |
EEPROM error |
| DETECTION CONDITION |
- Conditions: Ignition switch ON
- Circumstances: Different values detected for EEPROM and RAM
- Time period: Determined after 1 time
Diagnostic support note:
- The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- The AT warning light illuminates.
- PENDING CODE is not available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- TCM uses the default value as the initial value for EEPROM
|
| POSSIBLE CAUSE |
|
| SYSTEM WIRING DIAGRAM |
- |