Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA on repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information If the vehicle is not repaired, go to the next step.
2		No	Go to the next step
3	INSPECT APP SENSOR CONNECTOR CONDITION Switch the ignition to off Disconnect the APP sensor connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion) Is there any malfunction?	Yes	Repair or replace the terminal and/or connector, then go to Step 8.
3		No	Go to the next step.
4	INSPECT PCM CONNECTOR CONDITION Disconnect the PCM connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal and/or connector, then go to Step 8.
4		No	Go to the next step.
5	INSPECT APP SENSOR NO. 2 CIRCUIT FOR SHORT TO GROUND Inspect for continuity between the following terminals and body ground APP sensor terminal A (wiring harness-side) APP sensor terminal B (wiring harness-side) Is there continuity?	Yes	Repair or replace the wiring harness for a possible short to ground, then go to Step 8.
5		No	Go to the next step.
6	INSPECT APP SENSOR NO. 2 Inspect the APP sensor No. 2 (See ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [L5] .) Is there any malfunction?	Yes	Replace the APP sensor, then go to Step 8. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [L5] .)
6		No	Go to the next step.
7	INSPECT APP SENSOR NO. 2 CIRCUIT FOR OPEN CIRCUIT Inspect for continuity between the following terminals APP sensor terminal A (wiring harness-side) and PCM terminal 1W (wiring harness-side) APP sensor terminal B (wiring harness-side) and PCM terminal 1AP (wiring harness-side) Is there continuity?	Yes	Go to the next step.
7		No	Repair or replace the wiring harness for a possible open circuit, then go to the next step.
8	VERIFY DTC TROUBLESHOOTING COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the M-MDS. Perform the KOEO/KOER self test. (See KOEO/KOER SELF TEST [L5] .) Is the same DTC present?	Yes	Replace the PCM, then go to the next step (See PCM REMOVAL/INSTALLATION [L5] .)
8		No	Go to the next step.
9	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE [L5] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection (See DTC TABLE [L5] .)
9		No	DTC troubleshooting completed.