DTC P1674:00 [L5]: Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSES
| DTC P1674:00 |
Control module software corrupted |
| DETECTION CONDITION |
- Indicates that an error occurred in the PCM This DTC is set in combination with P2105 00
Diagnostic support note
- This is a continuous monitor (CCM)
- The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA is available
- The DTC is stored in the PCM memory
|
| POSSIBLE CAUSE |
- Software incompatibility issue
|