DTC P061B:00 [L5]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION & POSSIBLE CAUSES

DTC P061B.00	Internal control module torque calculation performance problem
DETECTION CONDITION	Indicates that a calculation error occurred in the PCM. Diagnostic support note This is a continuous monitor (CCM) The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle. FREEZE FRAME DATA is available The DTC is stored in PCM memory
POSSIBLE CAUSE	NOTE: This DTC is an informational DTC and may be set in combination with a number of other DTCs which are causing the FMEM. Diagnose other DTCs first PCM connector or terminal malfunction PCM malfunction

DTC P061B.00

Internal control module torque calculation performance problem

DETECTION CONDITION

Indicates that a calculation error occurred in the PCM.

Diagnostic support note

This is a continuous monitor (CCM)
The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
FREEZE FRAME DATA is available
The DTC is stored in PCM memory

POSSIBLE CAUSE

NOTE:

This DTC is an informational DTC and may be set in combination with a number of other DTCs which are causing the FMEM. Diagnose other DTCs first

PCM connector or terminal malfunction
PCM malfunction