LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (On-Board Diagnostic (Engine Control System L5) (3 Of 5)) >> DTC P0507:00 [L5] >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded"?
Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY RELATED PENDING AND STORED DTC 
  • Switch the ignition to off, then to ON (engine off).
  • Verify pending and stored DTCs using the M-MDS
  • Are any other DTCs present?
Yes Go to the applicable DTC inspection
(See DTC TABLE [L5] .)
No Go to the next step
4 INSPECT VACUUM HOSE CONNECTION 
  • Visually inspect the vacuum hoses for connecting?
  • Is there any malfunction"?
Yes Reconnect the vacuum hose accurately, then go to Step 6.
No Go to the next step.
5 INSPECT ELECTRONIC THROTTLE CONTROL SYSTEM MALFUNCTION  Yes Replace the malfunctioning parts, then go to the next step.
(See ACCELERATOR PEDAL REMOVAL/INSTALLATION [L5] .)
(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L5] .)
No Go to the next step.
6 VERIFY DTC TROUBLESHOOTING COMPLETED 
  • Clear the DTC from the PCM memory using the M-MDS.
  • Start the engine and warm it up completely.
  • Depress the brake pedal for more than 14 s. 
  • Is the PENDING CODE for this DTC present"?
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [L5] .)
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE 
Yes Go to the applicable DTC inspection
(See DTC TABLE [L5] .)
No DTC troubleshooting completed.