On-Board System Readiness Tests Access Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.

Fig 1: Identifying DLC-2

Courtesy of MAZDA MOTORS CORP.

After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select "Powertrain".
  2. Select "OBD Test Modes".
  3. Select "Mode 1 Powertrain Data".
  4. Select "PCM".
- When using the PDS (Pocket PC)
  1. Select "OBDII Modes".
  2. Select "Mode 1 Powertrain Data".
  3. Select "PCM".
Then, select the "***SUP" and "**EVAL" PIDs in the PID selection screen.
Monitor those PIDs and check it system monitor is completed.