LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 631 (On-Board Diagnostic (Engine Control System MZI-3.7) (4 Of 5)) >> DTC P1000:00 [MZI-3.7] >> Notes

DTC P1000:00 [MZI-3.7]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE

DTC P1000:00 OBD-II systems readiness test not complete
DETECTION CONDITION 
  • The OBD monitors are carried out during the OBD drive cycle. DTC P1000:00 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.
POSSIBLE CAUSE 
  • The vehicle is new from the factory and has not yet completed an OBD-II Drive Cycle.
  • The battery or the PCM has been disconnected.
  • OBD-II monitor malfunction had occurred before completion of an OBD-II Drive Cycle
  • The PCM DTCs have been cleared with an M-MDS tester as part of a service process.
scientia non olet · About LEMON Manuals