LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (On-Board Diagnostic (Engine Control System MZI-3.7) (1 Of 5)) >> On-Board Diagnostic Test [MZI-3.7] >> On-Board System Readiness Tests Access Procedure

On-Board System Readiness Tests Access Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the M-MDS to the DLC-2.
    2. Fig 1: Locating DLC-2 Data Link Connector
    G06199562Courtesy of MAZDA MOTORS CORP.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS
    • When using the IDS (laptop PC)
      1. Select "Powertrain"
      2. Select "OBD Test Modes".
      3. Select "Mode 1 Powertrain Data"
      4. Select "PCM".
    • When using the PDS (Pocket PC)
      1. Select "OBD II Modes"
      2. Select "Mode 1 Powertrain Data".
      3. Select "PCM".
  3. Then, select the "***SUP" and "**EVAL" PIDs in the PID selection screen.
  4. Monitor those PIDs and check it system monitor is completed.
    NOTE:
    • If the on-board system readiness tests are not completed the PCM stores DTC P1000:00.
scientia non olet · About LEMON Manuals