LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 627 (Body System [Doors And Liftgate]) >> Front Door Removal/Installation >> Connector Removal Note

Connector Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the rubber boot outward.
    Fig 1: View Of Rubber Boot Removal
    G06205685Courtesy of MAZDA MOTORS CORP.
  2. Press the tab in the direction of arrow (1) shown in the figure using a tape-wrapped flathead screwdriver, and remove the connector from the body in the direction of arrow (2) shown in the figure.
    Fig 2: View Of Removing Connector From Body
    G06205686Courtesy of MAZDA MOTORS CORP.
  3. Lower the lever in the direction of arrow (1), and disconnect the connector in the direction of arrow (2).
Fig 3: Illustrating Disconnecting Connector
G06205687Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals