Active Command Modes Inspection [Blind Spot Monitoring (BSM)]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.
After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select "DataLogger".
  2. Select "Modules"
  3. Select "BSML" or "BSMR".
- When using the PDS (Pocket PC)
  1. Select "Module Tests"
  2. Select "BSML" or "BSMR".
  3. Select "DataLogger".
  Fig 1: Identifying Data Link Connector DLC-2 Location
  Courtesy of MAZDA MOTORS CORP.
Select the active command modes from the PID table.
Perform the active command modes, inspect the operations for each parts.
- If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.