Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE INSPECTION Perform the configuration for the SAS control module using the M-MDS (See SAS CONTROL MODULE CONFIGURATION .) Clear DTCs using the M-MDS (See CLEARING DTC .) Inspect the SAS control module DTCs (See DTC INSPECTION .) Are DTCs U0300:00, U2100:00 displayed?	Yes	Perform the SAS control module configuration, then go to the next step. (See SAS CONTROL MODULE CONFIGURATION .)
1		No	Go to the next step.
2	PERFORM SAS CONTROL MODULE DTC INSPECTION Inspect the SAS control module DTCs. (See DTC INSPECTION .) Are DTCs U0300:00, U2100:00 displayed?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	DTC troubleshooting completed.