Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE INSPECTION Perform the configuration for the SAS control module using the M-MDS (See SAS CONTROL MODULE CONFIGURATION .) Clear DTCs using the M-MDS (See CLEARING DTC .) Inspect the SAS control module DTCs (See DTC INSPECTION .) Are DTCs B10FD:55, B10FE:55 displayed?	Yes	Go to the next step.
1		No	DTC troubleshooting completed.
2	INSPECT SIDE AIR BAG SENSOR NO. 1 Verify that the correct side air bag sensor No. 1 is assembled. Are the driver-side and passenger-side side air bag sensors No. 1 installed correctly?	Yes	Go to the next step.
2		No	Replace the side air bag sensor No. 1. (See SIDE AIR BAG SENSOR NO. 1 REMOVAL/INSTALLATION .)
3	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear DTCs using the M-MDS (See CLEARING DTC .) Inspect the SAS control module DTCs. (See DTC INSPECTION .) Are DTCs B10FD:55, B10FE:55 displayed?	Yes	Replace the SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	DTC troubleshooting completed.