Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	INSPECT CONTACTS OF SAS CONTROL MODULE CONNECTORS WARNING: Handling the component parts improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings/cautions and the Service Information before handling the air bag system components. (See AIR BAG SYSTEM SERVICE WARNINGS .) (See AIR BAG SYSTEM SERVICE CAUTIONS .) Switch the ignition to off Disconnect the negative battery cable and wait for 1 min or more Are all SAS control module connectors securely connected?	Yes	Go to the next step
1		No	Reconnect the SAS control module connectors properly.
2	VERIFY POORLY CONNECTED DETECTOR BARS OF SAS CONTROL MODULE CONNECTORS Disconnect the SAS control module connectors Verify the condition of the poorly connected detector bars of the SAS control module connectors (Corrosion, damage, and disconnected pins) Are the poorly connected detector bars of the SAS control module connectors normal?	Yes	Go to the next step.
2		No	Replace the air bag wiring harness
3	PERFORM SAS CONTROL MODULE DTC INSPECTION Connect the SAS control module connectors Connect the negative battery cable Switch the ignition to ON Clear DTCs using the M-MDS (See CLEARING DTC .) Inspect the SAS control module DTCs (See DTC INSPECTION .) Is DTC B1011:95 displayed?	Yes	Replace the SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	DTC troubleshooting completed