Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM SEAT WEIGHT SENSOR CALIBRATION Perform the calibration for the seat weight sensor using the M-MDS (See SEAT WEIGHT SENSOR CALIBRATION ) Clear DTCs using the M-MDS. (See CLEARING DTC .) Verify DTCs using the M-MDS. (See DTC INSPECTION .) Are DTCs B00A0:54 displayed.	Yes	Perform the seat weight sensor calibration, then go to the next step. (See SEAT WEIGHT SENSOR CALIBRATION .)
1		No	Go to the next step.
2	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear DTCs using the M-MDS. (See CLEARING DTC .) Verify DTCs using the M-MDS (See DTC INSPECTION .) Are DTCs B00A0:54 displayed.	Yes	Replace the seat weight sensor control module (See SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	DTC troubleshooting completed.