Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE INSPECTION Perform the configuration for the SAS control module using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION .) Clear DTCs using the M-MDS. (See CLEARING DTC .) Inspect the SAS control module DTCs. (See DTC INSPECTION .) Are DTC B0094:55 displayed?	Yes	Perform the SAS control module configuration, then go to the next step. (See SAS CONTROL MODULE CONFIGURATION .)
1		No	Go to the next step.
2	INSPECT CRASH ZONE SENSOR Verify that the correct pre-tensioner seat belt is assembled. Crash zone sensor assembly incorrect. Are the crash zone sensor installed correctly?	Yes	Go to the next step.
2		No	Replace the crash zone sensor. (See CRASH ZONE SENSOR REMOVAL/INSTALLATION .)
3	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear DTCs using the M-MDS. (See CLEARING DTC .) Inspect the SAS control module DTCs (See DTC INSPECTION .) Are DTC B0094:55 displayed?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	DTC troubleshooting completed.