Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE INSPECTION Perform the configuration for the SAS control module using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION .) Clear DTCs using the M-MDS. (See CLEARING DTC .) Inspect the SAS control module DTCs. (See DTC INSPECTION .) Are DTCs B0070:55, B0072:55 displayed?	Yes	Perform the SAS control module configuration, then go to the next step. (See SAS CONTROL MODULE CONFIGURATION .)
1		No	Go to the next step.
2	INSPECT PRE-TENSIONER SEAT BELT Verify that the correct pre-tensioner seat belt is assembled. Are the driver-side and passenger-side pre-tensioner seat belts installed correctly?	Yes	Go to the next step.
2		No	Replace the pre-tensioner seat belt. (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
3	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear DTCs using the M-MDS. (See CLEARING DTC .) Inspect the SAS control module DTCs. (See DTC INSPECTION .) Are DTCs B0070:55, B0072:55 displayed?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION )
3		No	DTC troubleshooting completed.