Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE CONFIGURATION Perform the configuration for the SAS control module using the M-MDS (See SAS CONTROL MODULE CONFIGURATION .) Clear DTCs using the M-MDS (See CLEARING DTC .) Inspect the SAS control module DTCs. (See DTC INSPECTION .) Are DTCs B0001:55, B001055 displayed.	Yes	Perform the SAS control module configuration, then go to the next step (See SAS CONTROL MODULE CONFIGURATION .)
1		No	Go to the next step.
2	INSPECT AIR BAG MODULE Verify that the correct driver-side air bag module or passenger-side air bag module is assembled Are the driver-side and passenger-side air bag modules installed correctly?	Yes	Go to the next step
2		No	Replace the driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .) Replace the passenger-side air bag module (See PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .)
3	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear DTCs using the M-MDS (See CLEARING DTC .) Inspect the SAS control module DTCs (See DTC INSPECTION .) Are DTCs B0001:55, B0010:55 displayed	Yes	Replace the SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	DTC troubleshooting completed