LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Automatic Transaxle [Shift Mechanism]) >> Shift-Lock Solenoid Inspection

Shift-Lock Solenoid Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the selector lever component connector
    1. Disconnect the negative battery cable
    2. Remove the rear console. See REAR CONSOLE REMOVAL/INSTALLATION .
    3. Disconnect the selector lever component connector
      Fig 1: Identifying Selector Lever Component Connector
      G06205949Courtesy of MAZDA MOTORS CORP.
  2. According to the table, measure the voltage between selector lever component terminals and body GND.
    • If there is any malfunction, repair or replace the related wiring harness.
    • If there is no malfunction, replace the selector lever component. See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .
      VOLTAGE SPECIFICATION

      Terminal Connected to Test condition Voltage (V)
      E-GND Brake switch Brake pedal depressed B+
      Brake pedal released Below 1.0
      I-GND Ignition switch Switch the ignition to ACC or ON B+
      Switch the ignition to off Below 1.0
      K-GND Body GND Under any conditions Below 1.0
      Fig 2: Measuring Voltage Between Selector Lever Component Terminals And Body GND
      G06205961Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals