Selector Lever Component Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the selector lever component connector.
1. Disconnect the negative battery cable.
2. Remove the rear console. See REAR CONSOLE REMOVAL/INSTALLATION .
3. Disconnect the selector lever component connector.
  
  Fig 1: Identifying Selector Lever Component Connector
  Courtesy of MAZDA MOTORS CORP.
Verify that the continuity is as indicated in the table
- If there is any malfunction, replace the selector lever component. See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .
  
  Fig 2: Identifying Selector Lever Component Connector Terminals
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 3: Terminals Continuity Chart
  Courtesy of MAZDA MOTORS CORP.