LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Automatic Transaxle [Shift Mechanism]) >> Selector Cable Adjustment

Selector Cable Adjustment

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the negative battery cable.
  2. Remove the rear console. See REAR CONSOLE REMOVAL/INSTALLATION .
  3. Shift the selector lever to the P position.
  4. Unlock the lock piece of the selector cable (selector lever side) in the order as shown in the figure.
  5. Verify that the manual shaft is in the P position.
    Fig 1: Identifying Lock Piece Of Selector Cable (Selector Lever Side)
    G06205954Courtesy of MAZDA MOTORS CORP.
  6. Lock the lock piece and safety lock of the selector cable (selector lever side) in the order as shown in the figure.
    Fig 2: Identifying Lock Piece Of Selector Cable (Selector Lever Side)
    G06205954Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals