LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Automatic Transaxle [Shift Mechanism]) >> Automatic Transaxle Shift Mechanism Removal/Installation >> Selector Lever Removal/Installation

Selector Lever Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the selector lever component connector.
    1. Disconnect the negative battery cable.
    2. Remove the rear console. See REAR CONSOLE REMOVAL/INSTALLATION .
    3. Disconnect the selector lever component connector.
  2. Remove the selector lever component.
    Fig 1: Identifying Selector Lever Component Connector
    G06205949Courtesy of MAZDA MOTORS CORP.
    1. Disconnect the selector cable from the selector lever.
      Fig 2: Identifying Selector Cable
      G06205950Courtesy of MAZDA MOTORS CORP.
    2. Remove the selector lever component
  3. Install in the reverse order of removal.
    Fig 3: Selector Lever Component Bolts And Torque Specifications
    G06205951Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals