Assist Handle Removal/Installation: Removal

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Insert a fastener remover into the assist handle service hole and remove the assist handle cover.

Fig 1: View Of Assist Handle Cover
Courtesy of MAZDA MOTORS CORP.
Insert the fastener remover in the position indicated by the arrow in the figure, push down the clip by moving the fastener remover in the direction of the arrow, and remove the assist handle from the assist handle bracket while shaking the assist handle up and down.
CAUTION:
- When inserting a fastener remover, be careful not to damage the tabs.
  
  Fig 2: View Of Assist Handle From Assist Handle Bracket
  Courtesy of MAZDA MOTORS CORP.