LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 617 (Rear Axle) >> Rear Wheel Hub Bolt Replacement

Rear Wheel Hub Bolt Replacement

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake caliper component and disc plate. (See WHEEL HUB COMPONENT REMOVAL/INSTALLATION ).
  2. Remove the wheel hub bolt using the SST as shown in the figure.
  3. Place a new wheel hub bolt in the wheel hub
    Fig 1: Removing Wheel Hub Bolt Using SST
    G06205458Courtesy of MAZDA MOTORS CORP.
  4. Install the wheel hub by placing a proper sized washer on the hub, and tightening the nut as shown in the figure.
    Fig 2: Tightening Wheel Hub Nut
    G06205453Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals