Preparation Prior To Inspection
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ABS wheel-speed sensor. See FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION .
- Remove the wheel hub, steering knuckle component. See WHEEL HUB, STEERING KNUCKLE REMOVAL/INSTALLATION .
- Install the ABS wheel-speed sensor to the removed wheel hub, steering knuckle component, and tighten to the specified torque.
Tightening torque
8-12 N.m {82-122 kgf.cm, 71-106 in.lbf}