Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	PERFORM DTC INSPECTION Clear the DTC using the M-MDS. (See CLEARING DTC [BCM] ) Perform the BCM DTC inspection using the M-MDS (See DTC INSPECTION [BCM] .) Is the same DTC present?	Yes	Replace the BCM, then go to the next step. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION .)
1		No	Go to the next step.
2	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [BCM] .)
2		No	DTC troubleshooting completed.