LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 611 (On-Board Diagnostic [Body Control System)) >> DTC B1D35:11 [BCM] >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
Step Inspection Action
1 PERFORM DTC INSPECTION 
  • Clear the DTC using the M-MDS. (See CLEARING DTC [BCM] )
  • Perform the BCM DTC inspection using the M-MDS with the hazard warning switch off (See DTC INSPECTION [BCM] .)
  • Is the same DTC present?
 Yes Go to the next step.
No Go to Step 7.
2 INSPECT HAZARD WARNING SWITCH CONNECTOR CONDITION 
  • Switch the ignition to off.
  • Disconnect the negative battery cable
  • Disconnect the hazard warning switch connector
  • Inspect the connector and terminals (corrosion, damage, pin disconnection)
  • Is there any malfunction?
 Yes Repair or replace the connector or terminals, then go to Step 6.
No Go to the next step.
3 INSPECT HAZARD WARNING SWITCH  Yes Replace the hazard warning switch, then go to Step 6. (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION .)
No Go to the next step.
4 INSPECT BCM CONNECTOR CONDITION 
  • Disconnect the BCM connector.
  • Inspect the connector and terminals (corrosion, damage, pin disconnection).
  • Is there any malfunction?
 Yes Repair or replace the connector or terminals, then go to Step 6
No Go to the next step
5 INSPECT HAZARD WARNING SWITCH CIRCUIT FOR SHORT TO GROUND 
  • Inspect for continuity between hazard warning switch terminal B (wiring harness-side) and body ground
  • Is there continuity?
 Yes Repair or replace the wiring harness for a possible short to ground, then go to the next step.
No Go to the next step.
6 VERIFY TROUBLESHOOTING COMPLETED 
  • Make sure to reconnect the disconnected connectors.
  • Reconnect the negative battery cable
  • Clear the DTC using the M-MDS. (See CLEARING DTC [BCM] .)
  • Perform the BCM DTC inspection using the M-MDS with the hazard warning switch off. (See DTC INSPECTION [BCM] .)
  • Is the same DTC present?
 Yes Repeat the inspection from Step 1.
If the malfunction recurs, replace the BCM, then go to the next step. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION .)
No Go to the next step.
7 VERIFY THAT NO OTHER DTCs ARE PRESENT 
  • Are any DTCs present?
 Yes Go to the applicable DTC inspection. (See DTC TABLE [BCM] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals