LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 609 (Wheels And Tires & Tire Pressure Monitoring System) >> Wheel Unit Id Registration >> Using M-MDS

Using M-MDS

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the M-MDS to DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • This function is available for only the IDS (notebook PC)
      1. Select the "Body".
      2. Select the "TPMS Functions".
      3. Select the "Wheel Unit ID Registration".
  3. Select an item from the screen menu.
    • Wheel unit ID registration: WU ID Registration
    • Monitoring wheel unit ID: Monitor WU ID Registration
      Fig 1: Identifying DLC-2
      G06205384Courtesy of MAZDA MOTORS CORP.
  4. Leave the vehicle with the ignition to off for 15 min or more. 
  5. Switch the ignition to ON (engine ON).
  6. Verify that the TPMS warning light turns on and off in 0.5 s  cycles repeatedly.
  7. Drive the vehicle at a speed of 25 km/h {15.5 mph} or more  for 10 min  to implement the wheel unit ID registration.
    NOTE:
    • If the ID registration is not completed even after driving the vehicle for 10 min  or more at a speed of 25 km/h {15.5 mph} or more  , the TPMS warning light flashes.
  8. Verify that the TPMS warning light turns off.
    NOTE:
    • If the wheel unit ID registration cannot be performed after driving 10 min or more, refer to the appropriate symptom troubleshooting procedure.
scientia non olet · About LEMON Manuals