Remaining Amount of Unbalance Confirmation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

After installing the outer and inner balance weights, operate the wheel balancer again.

Confirm that the remaining unbalance does not exceed the following on either side.

If the remaining unbalance exceeds the specifications, adjust the wheel balance again.

Specifications

SPECIFICATIONS

	Outer (Adhesive-type)	Inner (Knock-type)
17 inch wheel	14 g {0.49 oz}	9 g {0.3 oz}
18 inch wheel	13 g {0.46 oz}	8 g {0.28 oz}