Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	IDENTIFY MALFUNCTIONING WHEEL UNIT Identify the malfunctioning wheel unit See MALFUNCTIONING WHEEL UNIT IDENTIFICATION . Is there any malfunction?	Yes	Replace and register the malfunctioning wheel unit, then go to the next step See WHEEL UNIT REMOVAL/INSTALLATION . See WHEEL UNIT ID REGISTRATION .
1		No	Go to the next step
2	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from the memory using the M-MDS See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min Perform the DTC inspection using the M-MDS See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Is the same DTC present?	Yes	Repeat the inspection from Step 1
2		No	Go to the next step
3	VERIFY AFTER REPAIR PROCEDURE Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min Are any DTCs present?	Yes	Go to the applicable DTC inspection See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .
3		No	DTC troubleshooting completed.