Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT TIRE Inspect the tire Is there any scratch or foreign object?	Yes	Remove any foreign object or replace the tire if necessary, then go to the next step.
1		No	Go to the next step
2	INSPECT TIRE PRESSURE Measure the tire pressure when the tires are cold Is the tire pressure correct?	Yes	Go to the next step
2		No	Adjust the tire pressure to the specification, the go to the next step
3	PERFORM DTC INSPECTION Clear the DTC from the memory See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min Perform the DTC inspection using the M-MDS. See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Is the same DTC present?	Yes	Confirm the snapshot data If the tire pressure displayed on the snapshot is not correct, replace and register the wheel unit, then go to the next step See WHEEL UNIT REMOVAL/INSTALLATION . See WHEEL UNIT ID REGISTRATION .
3		No	Go to the next step
4	VERIFY AFTER REPAIR PROCEDURE Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min. Are any DTCs present?	Yes	Go to the applicable DTC inspection See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .
4		No	DTC troubleshooting completed.