LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 605 (Rear Suspension System) >> Rear CROSSMEMBER Removal/Installation >> Crossmember Component Installation Note

Crossmember Component Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Installing the crossmember component is dangerous. The crossmember component could fall and cause serious injury or death. Verify that the jack securely supports the crossmember component.
  1. Support the crossmember component using a jack.
  2. Install the crossmember component.
  3. Install the rear upper arm outer side.
    Fig 1: Supporting Crossmember Component Using Jack
    G06205427Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals