LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Automatic Transaxle [Service, Removal & Installation Aw6A-El)) >> Solenoid Valve Inspection [Aw6A-El] >> Resistance Inspection (On-Vehicle Inspection)

Resistance Inspection (On-Vehicle Inspection)

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7] .)
  3. Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL] .)
  4. Measure the resistance between the following terminals.
    Fig 1: Identifying Coupler Component
    G06200115Courtesy of MAZDA MOTORS CORP.
    Fig 2: Identifying Coupler Component Terminals
    G06200110Courtesy of MAZDA MOTORS CORP.
    • If there is any malfunction, inspect the coupler component.
    • If the coupler component is normal, perform the following action.
SOLENOID VALVE RESISTANCE (ATF TEMPERATURE: 20°C {68°F})

Terminal Solenoid valve Resistance (ohm) Action
B5-GND Shift solenoid A 11-15
  • Replace the shift solenoid A.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL] .)
B2-GND Shift solenoid B 11-15
  • Replace the shift solenoid B.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL] .)
B11-B10 Shift solenoid C 5.0-5 6
  • Replace the control valve body.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL] .)
B17-B18 Shift solenoid D 5.0-5 6
B14-B22 Shift solenoid E 5.0-5 6
B21-B16 Shift solenoid F 5 0-5.6
B9-B4 TCC control solenoid 5.0-5 6
B3-B1 Line pressure control solenoid 5.0-5 6
scientia non olet · About LEMON Manuals