Continuity Inspection
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7] .)
- Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL] .)
- Inspect the continuity between the following terminals.
- If there is continuity, inspect the coupler component.
- If the coupler component is normal, perform the following action.
SOLENOID VALVE CONTINUITY
| Terminal | Continuity | Action |
|---|---|---|
| B1-GND | No continuity |
|
| B3-GND | No continuity | |
| B4-GND | No continuity | |
| B9-GND | No continuity | |
| B10-GND | No continuity | |
| B11-GND | No continuity | |
| B14-GND | No continuity | |
| B16-GND | No continuity | |
| B17-GND | No continuity | |
| B18-GND | No continuity | |
| B21-GND | No continuity | |
| B22-GND | No continuity |