LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 602 (Automatic Transaxle [Service, Removal & Installation Aw6A-El)) >> Differential Gear O-Ring Replacement [Aw6A-El]

Differential Gear O-Ring Replacement [Aw6A-El]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • The O-ring is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the O-ring.
  1. Remove the drive shaft and joint shaft. (See JOINT SHAFT REMOVAL/INSTALLATION .) (See DRIVE SHAFT REMOVAL/INSTALLATION .)
    CAUTION:
    • Do not damage the differential case.
  2. Remove and discard the O-ring using a tape-wrapped flathead screwdriver.
    CAUTION:
    • Do not damage the O-ring.
    • Do not damage the differential case.
    Fig 1: Removing O-Ring
    G04970359Courtesy of MAZDA MOTORS CORP.
  3. Apply ATF to a new O-ring and install it to the differential case.
  4. Install the drive shaft and joint shaft. (See JOINT SHAFT REMOVAL/INSTALLATION .) (See DRIVE SHAFT REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals