No. 4 Engine Mount Bracket Installation Note
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Install the No. 4 engine mount bracket to the transaxle.
- Temporarily tighten bolt A.
- Temporarily tighten nuts B, C and bolt D.
- Tighten nuts and bolt in the order of C→B→D.
- Tighten bolt A.
Courtesy of MAZDA MOTORS CORP.
Tightening torque
Bolt A: 86-116 N.m {8.7-11 kgf.m, 63-85 ft.lbf}
Nut B, C, Bolt 0:67-93 N.m {6.8-9.4 kgf.m, 50-68 ft.lbf}