Automatic Transaxle Fluid (ATF) Replacement [Aw6A-El]
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
- Remove the oil dipstick.
- Remove the oil drain plug and gasket to drain the ATF into a container.
- Install a new gasket and the drain plug.
Tightening torque
23.5-54.9 N.m {2.4-5.5 kgf.m, 17.4-40.4 ft.lbf}
- Add the specified ATF through the oil filler tube until it reaches the lower notch of dipstick.
ATF
Type: JWS3309
Capacity (Approx. quantity): 7.0 L {7.4 US qt, 6.2 lmp qt}
- Inspect the ATF level (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [AW6A-EL] .)