Automatic Transaxle Fluid (ATF) Level Inspection
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The ATF amount varies according to ATF temperature. Therefore, when checking the ATF level or replacing the ATF, use a thermometer to measure the temperature and adjust the ATF amount to the specified level according to the specified temperature.
- Place the vehicle on level ground
- Apply the parking brake and position wheel chocks securely to prevent the vehicle from rolling.
- Connect the M-MDs to the DLC-2.
- Monitor the ATF temperature using the M-MDS.
- Warm up the transaxle until the ATF reaches 60-70°C {140-158°F}.
- Shift the selector lever and pause momentarily in each range (P-D) while depressing the brake pedal.
- Shift the selector lever to P position
- Verify that the ATF level is in the HOT range (65°C {149°F})
while the engine is idling
- If necessary, add ATF to the specification
ATF type
JWS3309
- If necessary, add ATF to the specification